Filter
Top Products
Digital Waveform and Digital List Commands
WFM 601A, WFM 601E & WFM 601M User Manual
C–21
DGTL:REGion? (WFM 601M Only)
Returns the region of the video signal where the data cursor is located. Possible
regions include active picture, horizontal blanking, and vertical blanking.
DGTL:REGION?
None
dgtl:region?
:DGTL:REGION ACTIVE
DGTL:DATA? (WFM 601M Only)
DGTL:DATA:V#?
NOTE. The values displayed when using this command are accurate only when
the waveform monitor is in the Data List mode.
DGTL:DATA? returns 15 data samples centered on the currently selected sample
(see LINESelect: commands on page C–42). This region data corresponds to the
data seen on the Digital Video display.
DGTL:DATA:V#? returns only the numbered sample from the 15 displayed,
counting from the top down. Sample 7 is always the sample selected by the data
cursor. This sample corresponds to V7 on the display.
Change the display mode to Digital List using the DISPlay:SINGLE <display
mode> command (page C–25) before using this command.
Syntax
Arguments
Examples
Returns