Filter
Top Products
Configuration Commands
WFM 601A, WFM 601E & WFM 601M User Manual
C–13
SERial:EAVSAV <PASS | STRIP>
This command permits stripping of the END/START of ACTIVE VIDEO
information from the displayed signal. This selection corresponds to the choices
available under EAV–SAV in the CONFIG WFM/VEC menu.
SERial:EAVSAV <PASS | STRIP>
SERial[:EAVSAV]?
<PASS | STRIP>
ser:eavsav pass
serial:eavsav strip
ser:eavsav?
:SERIAL:EAVSAV STRIP
SERial:ALarm:<error type> <alarm setting>
These commands select or disable checking for several types of format errors and
correspond to the error selections available in the CONFIG SER ALARM menu.
Table C–2 lists the SERial:ALarm error type commands <error type> and
options <alarm setting>.
Use the UIMENU:CONFIGSEL SERIALARM command (page C–14) to put the
waveform monitor into the serial alarm mode before using this command.
SERial:ALarm:<error type> <alarm setting>
SERial[:ALarm | :ALarm:<error type>]?
:<error type> <alarm setting>
Syntax
Arguments
Examples
Returns
Syntax
Arguments