Filter
Top Products
Reference Manual
00809-0100-4663, Rev BA
January 2010
Rosemount 8732
B-2
Rosemount 8721 Sanitary Magmeter Sensors
in line sizes of 1
1
/2 in. and larger:
Module A Conformity Assessment
All other Rosemount 8705/8707/8711/8721
Sensors —
in line sizes of 1 in. and less:
Sound Engineering Practice
Sensors that are SEP are outside the scope of PED and cannot be marked for compliance with
PED.
Mandatory CE-marking for sensors in accordance with Article 15 of the PED can be found on the
sensor body (CE 0575).
Sensor category I is assessed for conformity per module A procedures.
Sensor categories II – IV, use module H for conformity assessment procedures.
Electro Magnetic Compatibility (EMC) (2004/108/EC)
Models 8712D - EN 50081-1: 1992, EN 50082-2: 1995,
Model 8732E - EN 61326: 1997: A1 + A2 + A3
Installed signal wiring should not be run together and should not be in the same cable tray as AC
power wiring.
Device must be properly grounded or earthed according to local electric codes.
To improve protection against signal interference, shielded cable is recommended.
Low Voltage Directive (93/68/EEC)
Model 8712D - EN 61010 -1: 1995
Low Voltage Directive (2006/95/EC)
Model 8732E - EN 61010 -1: 2001
Other important guidelines
Only use new, original parts.
To prevent the process medium escaping, do not unscrew or remove process flange bolts,
adapter bolts or bleed screws during operation.
Maintenance shall only be done by qualified personnel.
CE CE Marking
Compliance with all applicable European Union Directives. (Note: CE Marking is not
available on Rosemount 8712H).
IECEx Scheme
For Rosemount 8732E transmitters:
Rosemount complies with all of the stated standards below:
IEC 60079-0 : 2004
IEC 60079-1 : 2007-04
IEC 60079-11 : 2006
IEC 60079-26 : 2006
IEC 60079-7 : 2006-07
IEC 61010-1 : 2001
IEC 61241-0 : 2004
IEC 61241-1 : 2004
C-Tic Marking
Complies with IEC 61326-1 : 1997 + A1, A2, A3.