Filter
Top Products
Reference Manual
00809-0100-4663, Rev BA
January 2010
3-7
Rosemount 8732
Measured Reverse Total
Measured reverse total provides the output reading of the totalizer. This value
is the amount of process fluid that has passed through the flowmeter in the
reverse direction since the totalizer was last reset. This value is only totalized
when reverse flow is enabled.
Start Totalizer
Start totalizer starts the totalizer counting from its current value.
Stop Totalizer
Stop totalizer interrupts the totalizer count until it is restarted again. This
feature is often used during pipe cleaning or other maintenance operations.
Reset Totalizer
Reset totalizer resets the net totalizer value to zero. The totalizer must be
stopped before resetting.
NOTE
The totalizer value is saved in the Non-Volatile memory of the electronics
every three seconds. Should power to the transmitter be interrupted, the
totalizer value will start at the last saved value when power is re-applied.
Pulse Output The Pulse Output displays the current value of the pulse signal.
BASIC SETUP The basic configuration functions of the Rosemount 8732 must be set for all
applications of the transmitter in a magnetic flowmeter system. If your
application requires the advanced functionality features of the Rosemount
8732, see Section 4 "Operation" of this manual.
Tag Tag is the quickest and shortest way of identifying and distinguishing between
transmitters. Transmitters can be tagged according to the requirements of
your application. The tag may be up to eight characters long.
Flow Units Flow Units set the output units for the Primary Variable which controls the
analog output of the transmitter.
Primary Variable Units
The Primary Variable Units specifies the format in which the flow rate will be
displayed. Units should be selected to meet your particular metering needs.
Fast Keys 1, 1, 4, 4
Fast Keys 1, 1, 4, 5
Fast Keys 1, 1, 4, 6
Fast Keys 1, 1, 4, 7
Fast Keys 1, 1, 5
Fast Keys 1, 3
Fast Keys 1, 3, 1
Fast Keys 1, 3, 2
Fast Keys 1, 3, 2, 1