Filter
Top Products
6. ASSEMBLY
BAS-311G, BAS-326G
81
6-11. Lower shaft mechanism
5. Rock gear shaft
(Insert from the rear of the machine head)
6. Rock gear
7. Set screw collar, B
8. Set screws [2 pcs]
9. Set screw collar, R
10. Set screw (Temporarily tighten)
11. Set screws [2 pcs] (Temporarily tighten)
While turning the machine pulley, move the
rock gear back and forth to the position
where it turns smoothly.
Place set screw collar R against the edge
of the bed and tighten the set screw.
5145Q
1. Shuttle race base assy
2. Set screw
3. Set screw
4. Adjusting stud
Tighten the set screw until the head o
f
the screw is flush with the edge of the
bed. (Refer to “7-8. Rotary hoo
k
lubrication amount”.)
5144Q
A
djust while referring to “7-19. Adjusting
the backlash of the lower shaft gear”.