Filter
Top Products
6. ASSEMBLY
BAS-311G, BAS-326G
65
1) With the screw stop of the work clamp pulse motor facing
downward and the index mark on the work clamp driving gea
r
facing to the right, adjust so that the clearance between the
work clamp pulse motor and the work clamp driving gear is 6.2
mm, and then tighten the two set screws.
15. Work clamp pulse moto
r
16. Work clamp driving gear
17. Set screws [2 pcs]
18. Work clamp motor plate
19. Bolts [4 pcs]
20. Bolts [2 pcs]
2) Install the work clamp pulse motor to the work clamp
motor plate with the four bolts so that the moto
r
connector is facing downward.
3) Align the index marks on the work clamp cam gea
r
and the work clamp driving gear, and then install the
work clamp motor plate with the two bolts so tha
t
there is no backlash.
5170Q
5171Q
5172Q
Index mark
Index mark