Filter
Top Products
2. FUNCTION SETTINGS
13
BAS-311G, BAS-326G
Error processing settings
No.
Setting
range
Setting items Initial value
Error release method when operation has stopped
0 Press the RESET key.
1 Press the RESET key or the STOP switch.
650
2 Press the RESET key or input a signal from the external switch (EXIN3).
0
Needle stop position when sewing is interrupted by the STOP switch
0 Needle stops in the down position.
1 Needle stops in the up position.
651
2 Needle stops in the up position after thread trimming.
0
Thread trimming operation when sewing is paused
OFF Thread trimming is carried out when the pause is canceled.
652
ON Thread trimming is not carried out when the pause is canceled.
OFF
Resuming sewing after sewing is paused
OFF
STOP switch → RESET key →
key → Sewing starts
653
ON
STOP switch → RESET key → Sewing starts
OFF
Disables the needle up stop position monitoring sensor
OFF Sensor is enabled and needle up stop position errors [E110] are detected.
655
ON Disabled
OFF
Home position return when sewing is paused
OFF Mechanism moves to home position and then moves to sewing start position.
656
ON
Mechanism steps back to the sewing start position along the sewing path without
moving to the home position.
OFF
Maintenance settings
No.
Setting
range
Setting items Initial value
Run-in operation mode
0 Disabled
1
While the foot switch is being depressed, the work clamp moves up and down
once and then continuous operation starts.
(Work clamp does not move up or down if memory switch No. 050 = 2 or 4)
2
While the foot switch is being depressed, the work clamp moves up and down
twice and then continuous operation starts.
(Work clamp does not move up or down if memory switch No. 050 = 2 or 4)
750
3
While the foot switch is being depressed, the work clamp moves up and down
three times and then continuous operation starts.
(Work clamp does not move up or down if memory switch No. 050 = 2 or 4)
0
Run-in operation cycle time adjustment timer
751
0 − 255
Units [x10 ms]
20
Sewing machine ID code
752
00 − 99
Sewing data specified on CF card
00
Reading/writing sewing data for old models
OFF Only compatible with floppy disks.
755
ON Reading and writing using CF cards is possible in data read/write mode.
OFF
Main shaft angle display mode
OFF Disabled
756
ON Main shaft angle is displayed when sewing machine starts.
OFF
Specifications and destination settings
No.
Setting
range
Setting items Initial value
Specification code setting
(This memory switch does not return to the initial value when all settings are reset.)
0
Specifications at the time of shipment from the factory
(Specifications shown on the model plate on the machine head)
1 Heavy-weight material specifications
2 Medium-weight material specifications
850
3 Extra heavy-weight material specifications
0