Filter
Top Products
7. ADJUSTMENT
BAS-311G, BAS-326G
109
3
Press the
or key to set the offset value (-9 - 10).
• When you press the key, the needle bar will drop, and when you
press the key, it will rise.
NOTE:
After changing the offset value, check that the thread trimming
operation is normal and that error [E110] is not generated.
4
Depress the foot switch to the 2nd step.
(If using a two-pedal foot switch, lower the work clamp before
depressing the start switch.)
• The upper shaft will move and stop at the offset value that has been
set.
5
End adjustment mode.
TEST indicator switches off
Press the TEST key.
• The offset value will be memorized and the sewing machine will
switch to home position detection standby.
2nd step
4441Q
5212Q