Filter
Top Products
Chapter 8 Page 205
The HotSync Manager is now communicating with the simulated port defined for infrared
communication.
Note: You cannot use your cable again until you reconfigure the HotSync Manager to
communicate with the port defined for cable synchronization.
To configure HotSync Manager for infrared communication with Windows 2000:
1. If necessary, start HotSync Manager.
2. Click the HotSync Manager icon in the Windows system tray.
3. Choose InfraRed from the HotSync Manager menu.
Performing an IR HotSync operation
After you complete the steps to prepare for an IR HotSync operation it is easy to perform the
actual operation.
To perform an IR HotSync operation:
1. Press Option and then press Menu to access the Applications Launcher.
2. Tap the HotSync icon .
3. Tap Local.
4. Tap the pick list below the HotSync icon and select IR to a PC/Handheld.
5. Position your communicator’s IR port within a couple of inches of your computer’s infrared
port.
6. Tap the HotSync icon to start the IR HotSync operation.