Filter
Top Products
14. PROGRAMMING MODE EO1-31009
14.2 PLU Data Setting
14- 10
Item Procedure
LOGO 1. Input a logo number (0000 – 9999)
2. Touch the LOGO area.
Or,
1. Touch the LOGO area.
2. The logo list will appear.
3. Select the desired logo number
from the list.
NOTES:
1. Max. 3 logos can be set to one PLU.
2. Logos can be called only from the flash memory card (ATA card).
3. File format, file name, and size of the logos should meet the following:
Format: Windows BMP, monochrome
File name: LOGOxxxx.BMP (xxxx is any 4-digit number and will be a code
number)
Size: Max. 600 dots (W) x 400 dots (H) (Both numbers must be multiple of
8.)
4. 1 pixel = 0.125 mm
For example, a 320-dots by 240-dot logo data will be printed as 40 mm by
30 mm.
5. Printable logo width differs depending on the label width.
Logos which are larger than the above size can be programmable,
however, the part outside the specified size will not be printed.
Safe Handling Instructions 1. Input a safe handling instruction number (0 – 10).
2. Touch the SAFE HANDLING area.
NOTES:
1. Safe handling instructions can be called only from the flash memory card
(ATA card).
2.For the safe handling instruction’s format and size, refer to the NOTES for
the LOGO setting. However, the file name should be set as follows:
File name: Shi00xx.bmp (xx is 2-digit number from 02 to 10)
3. Safe handling instruction No. 0 means that nothing is printed.
2. Safe handling instruction No. 1 means that the scale’s default data is
printed.
Label width Printable logo width Print size
80 mm 600 dots 75 mm
57 mm 440 dots 55 mm
48 mm 380 dots 47.5 mm