Filter
Top Products
15. SET UP MODE EO1-31009
15.7 Wireless LAN
15-50
Procedure
Item Procedure
Setting the ESS ID 1. Touch the ESS ID area.
2. The Edit screen will appear.
3. Input an alphanumeric data. (Refer to NOTE 1.)
Setting the encryption
status
Touch the Yes or No area. When the Yes area is touched, the WEP
type and WEP key code settings will be effective. (Refer to NOTE 2.)
Selecting the WEP key type Touch the ASCII or HEX area.
Setting the transmit key 1. Touch the Transmit key area.
2. The Edit screen will appear.
3. Enter a transmit key name.
Setting Authentication Touch the Open-system or Shared-key area. (Refer to NOTE 3.)
Default key number Select one of the transmit keys. Each time the Default Key No. window
is touched, the displayed number changes among 1 to 4.
Setting Antenna 1. Touch the Antenna selection area.
2. The following menu will appear.
3. Select the Diversity, ANTENNA-A, or ANTENNA-B.
NOTES:
1. ESSID (Extended Service Set Identifier (IEEE802.11))
Max. 32 characters (32 byte ASCII)
The vacant area should be set to zero. The default setting is zero.
2. Encryption (Enable/Disable, WEP type, eacp WEP key code)
ASCII 5 characters or 10 digit HEX code.
All digits should be filled, or an error occurs and entered data is cleared.
The default setting is all zeros, which means the encryption is disabled.
Level Key length ASCII Example
40 bit 0x + 10 digits 5 characters 0xABCDE23456
128 bit 0x + 26 digits Disabled 26 digits = 5+4+4+4+4
3. Authentication (Open-system/Shared-key)
It depends on the Access Point setting.