Filter
Top Products
8. LOADING/REPLACING THE MEDIA EO1-31009
8. LOADING/REPLACING THE MEDIA
8- 3
5. Move the media guide to the label edge.
NOTE: When the labels are issued in strip mode, provide about 1 mm gap between the backing paper
edge and the media guide.
6. To issue the label in the strip mode, skip this step. To issue the label in the batch mode, push the
label cassette into the scale with the top edge of the label protruding from the media outlet. Press
the [FEED] button to check that the labels are fed properly. Now the label loading for the batch
mode is completed.
7. When using the strip issue, remove the backing paper stopper from the take-up shaft.
FEED Button
Backing Paper Stopper
Take-up Shaft
Media Guide