Filter
Top Products
91
FWD WHEELCHAIRS PROCEDURE 17
F
W
D
W
H
E
E
L
C
H
A
I
R
S
This Procedure includes the following:
Removing/Installing Rear Shroud
Removing/Installing Front Shroud
Removing/Installing Side Shroud Assembly
Removing/Installing Counterweight
Replacing Group 24 Battery Box Sub-Frame
Removing/Installing Shocks
Shock Spring Replacement
Tie Rod Replacement
Removing/Installing Gearbox
Sensor Cable Assembly Replacement
Replacing Suspension Arm
Removing/Installing The Wiring Harness
Adjusting Weight Distribution
FIGURE 2 - REMOVING/INSTALLING FRONT
SHROUD
Front
Shroud
Wing Nut
Wing Nut
Mounting
Bracket
REMOVING/INSTALLING REAR
SHROUD (FIGURE 1)
Removing
1. Turn the two (2) wing nuts COUNTERCLOCKWISE
and lift up on the rear shroud.
Installing
1. Position the rear shroud on the wheelchair frame align-
ing the two (2) wing nuts with the mounting brackets.
2. Turn the two (2) wing nuts CLOCKWISE to secure
rear shroud in place.
Wing
Nut
Rear
Shroud
Wing
Nut
FIGURE 1 - REMOVING/INSTALLING REAR
SHROUD
REMOVING/INSTALLING FRONT
SHROUD (FIGURE 2)
Removing
1. Turn the two (2) wing nuts on the TOP of the front
shroud COUNTERCLOCKWISE.
2. Turn the wing nut on the BOTTOM of the front shroud
COUNTERCLOCKWISE and lift up on the front
shroud.
Installing
1. Position the front shroud on the wheelchair frame.
2. Align the wing nut on the BOTTOM of the front shroud
with the mounting bracket on the wheelchair frame.
3. Align the two (2) wing nuts on the TOP of the front
shroud with the mounting holes in the wheelchair frame.
4. Turn the wing nut on the BOTTOM of the front shroud
CLOCKWISE to secure front shroud in place.
5. Turn the two (2) wing nuts on the TOP of the front
shroud CLOCKWISE to secure front shroud in place.
WARNING
After ANY adjustments, repair or service
and BEFORE use, make sure that all at-
taching hardware is tightened securely -
otherwise injury or damage may result.
REMOVING/INSTALLING SIDE
SHROUD ASSEMBLY (FIGURE 3)
Removing
1. Remove the rear shroud. Refer to
REMOVING/INSTALL-
ING REAR SHROUD in this procedure of the manual.
2. Remove the drive wheel from the wheelchair. Refer
to
REMOVING/INSTALLING DRIVE WHEEL in PRO-
CEDURE 12 of this manual.