Filter
Top Products
28
FIGURE 6 - INSTALLING/REMOVING ADJUSTABLE SEAT FRAME SUBASSEMBLY AND/OR COMPONENT
REPLACEMENT
Mounting Screws
(Torque to 156-inch pounds)
Side Frame
Side Frame
Center Frame
Spacer
Locknuts
Support
Bracket
Base
Frame
Coved Washer
Locknuts
Locknuts
Support
Bracket
Mounting Screws
(Torque to 156-inch
pounds)
Mounting Screws
(Torque to 156-inch
pounds)
Mounting
Plate
Mounting Screws
(Torque to 75-inch
pounds)
1. Secure both support brackets to the seat mounting plates
with four (4) mounting screws and locknuts as shown in
FIGURE 6. Torque mounting screws to 156-inch pounds.
2. Secure the center frame to the support brackets with
four (4) mounting screws, locknuts, and spacers. Torque
to 156-inch pounds.
3. Insert the side frame into the center frame and secure
with mounting screw, coved spacer, spacer, and lock-
nut. Torque to 75-inch pounds. Repeat for opposite side
frame.
4. To complete conversion, refer back to the starting proce-
dure to complete the desired change.
Component Replacement
1. Perform the instructions outlined in
PREPARATIONS
FOR REMOVING/INSTALLING SEAT FRAME (STAN-
DARD FRAME, ADJUSTABLE FRAME, AND CAP-
TAINS VAN SEAT) in this procedure of the manual.
NOTE: Note the mounting hole position of the current side
frame(s) for proper installation of the NEW side frame(s).
2. Remove the two (2) mounting screws, coved spacers,
spacers, and locknuts that secure the side frame to the
center frame.
Mounting Screws
(Torque to 156-inch pounds)
PROCEDURE 6 SEAT FRAME
S
E
A
T
F
R
A
M
E