Filter
Top Products
40
BACK ANGLE ADJUSTMENT
(FIGURE 3)
1. Remove armrests from the wheelchair. Refer to IN-
STALLING/REMOVING FLIP BACK ARMRESTS in
PROCEDURE 4 of the owners manual, 1081227.
2. Remove the mounting screw and washer from the top
mounting hole of back angle plate and back cane.
NOTE: To avoid losing the insert in each back cane, thread
the mounting screw through the cane from the inside of
wheelchair to hold the insert in place.
TO ACHIEVE A BACK ANGLE OF:
ANGLE BACK CANE MOUNTING HOLE BACK ANGLE PLATE HOLE
80
O
Top TOP Front
Bottom BOTTOM Rear
85
O
Top TOP Front
2nd from Bottom BOTTOM Center
90
O
Top TOP Front
Bottom BOTTOM Front
95
O
Top TOP Center
2nd from Bottom BOTTOM Front
100
O
Top TOP Rear
Bottom BOTTOM Front
FIGURE 3 - BACK ANGLE ADJUSTMENT
3. Remove the mounting screw and washer from the
bottom mounting hole of the back angle plate and
back cane.
4. Reposition the back canes into the correct mount-
ing holes of the back angle plate to obtain a back
angle between 80
o
and 100
o
in 5
o
increments.
5. Torque mounting screws to 75-inch pounds.
6. Reinstall the armrests onto the wheelchair. Refer
to
INSTALLING/REMOVING FLIP BACK ARM-
RESTS in PROCEDURE 4 of the owners manual,
1081227.
BACK FRAMEPROCEDURE 8
B
A
C
K
F
R
A
M
E