Filter
Top Products
103
F
W
D
W
H
E
E
L
C
H
A
I
R
S
FWD WHEELCHAIRS PROCEDURE 17
FOOTREST ANGLE ADJUSTMENTS
WARNING
DO NOT remove detent pin from footrest
assembly. Otherwise, injury may result.
Footrest Angle Adjustment Relative to the
Vertical Position of the Front Shroud
(FIGURE 16)
NOTE: The angle of the footrest relative to the vertical
position of the front shroud can be increased or decreased
by adjusting both cams located at the top of the footrest
support.
1. Loosen the mounting screw and locknut that secure
the cams to the upper mounting bracket. Refer to
DETAIL A.
NOTE: Both cams MUST be rotated to the same posi-
tion to keep the footrest square to the base.
2. Rotate both cams either direction until footrest is at
desired angle. Refer to DETAIL B and C
3. Tighten mounting screw and locknut to 12 foot pounds.
Footrest Angle Adjustment Relative to the
Horizontal Position of the Front Shroud
(FIGURE 16)
NOTE: The footrest is factory set to be square to the base
when installed. The footrest can be positioned to be out of
square by adjusting only one (1) of the cams located at the
top of the footrest support.
1. Loosen the mounting screw and locknut that secure the
cams to the upper mounting bracket. Refer to DETAIL
A.
2. Perform one (1) of the following:
NOTE: Right and Left are determined by sitting in the
wheelchair.
A. Turning the right cam will rotate the footrest counter-
clockwise. Refer to DETAIL D.
B. Turning the left cam will rotate the footrest clock-
wise. Refer to DETAIL D.
3. When footrest is at desired position, tighten mounting
screw and locknut to 12 foot pounds.
FIGURE 15 - DEPTH/HEIGHT/ANGLE
ADJUSTMENT
Half Clamp
Side View Of 90
o
Footboard
Flat Screws
(Loosen
Here)
Flat Screws
Washers
Locknuts
Footboard
Caplug
Mounting Screw
Washer
Hub Cap
Locknut
Footrest
Support
DEPTH
ANGLE/HEIGHT
Two (2)
Mounting
Positions
Flat Screws
Washers
Locknuts
Footboard
Washer/
Locknut