Filter
Top Products
44
B
A
T
T
E
R
I
E
S
Group 22 Battery Base Frames (FIGURE 3)
NOTE: Refer to WARNINGSand CAUTIONS in the front
of this procedure.
NOTE: Note polarity of white battery cable (jumper)
battery terminal ends.
1. Remove battery terminal cap(s) from battery
terminal(s) ends. Refer to DETAIL A in FIGURE
3.
2. Connect WHITE battery cable (jumper) NEGATIVE
N
terminal end to NEGATIVE (-) battery terminal/
post of front battery and connect POSITIVE
P
ter-
minal end to POSITIVE (+) battery terminal/post of
rear battery.
3. Place battery top upside down on top of rear bat-
tery.
4. Connect NEGATIVE (-) BLACK battery cable of
the battery box top to NEGATIVE (-) battery termi-
nal/post of rear battery.
5. Position battery box top right side up and rotate
outward toward right to expose POSITIVE (+) bat-
tery terminal/post of front battery.
6. Connect POSITIVE (+) RED battery cable on battery
box top to POSITIVE (+) battery terminal/post of front
battery.
7. Replace battery terminal cap(s) onto battery cable
terminal end(s).
8. Rotate top toward left into position. Secure in place.
9. Install the battery box into the wheelchair. Refer to
INSTALLING/REMOVING 22NF BATTERY BOX in
the Owners Manual supplied with the chair.
NOTE: New Battery(ies) MUST be fully charged BE-
FORE using, otherwise the life of the battery(ies) will
be reduced.
10. If necessary, charge the battery(ies). Refer to
CHARGING BATTERIES in the Owners Manual
supplied with the wheelchair.
PROCEDURE 9 BATTERIES