Filter
Top Products
SECTION 12—ANTI-TIPPERS
At’m and At’m QT 72 Part No. 1125078
FIGURE 12.1 Removing/Installing the Anti-Tippers - At’m
At’m QT
NOTE: For this procedure, refer to FIGURE 12.2 on page 73.
Removing
1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.
2. Remove the battery box. Refer to Removing/Installing the Battery Box on the At’m QT
on page 46.
3. Remove the seat. Refer to Removing/Installing the Seat on page 31.
4. Remove the four coved washers, two washers and two locknuts that secure the
anti-tipper to the base frame.
NOTE: It is not necessary to remove the hex head screws from the wheelchair base to remove the
anti-tipper.
5. Repeat STEP 4 for the other anti-tipper.
Installing
1. Install the anti-tippers to the base frame using the four coved washers, two washers
and two locknuts.
2. Repeat STEP 1 for the other anti-tipper.
3. Install the battery box. Refer to Removing/Installing the Battery Box on the At’m QT
on page 46.
4. Install the seat. Refer to Removing/Installing the Seat on page 31.
5. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.
Mounting Bolts
Coved Washers
Washers
Washers
Locknuts
Washers
Coved Washers
Washers
Base Frame
Anti-Tippers