Filter
Top Products
SECTION 8—BATTERIES
At’m and At’m QT 48 Part No. 1125078
Installing
1. Install the batteries into the battery pack in the orientation shown in FIGURE 8.4.
2. Connect the wiring harness to the batteries in the following order -
A. NEGATIVE (-) BLACK battery cable to the NEGATIVE (-) battery terminal on the
left battery.
B. POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post on the right
battery.
C. WHITE battery cable (jumper) to the POSITIVE (+) battery terminal/post on the left
battery and the NEGATIVE (-) battery terminal/post on the right battery.
3. Slide the red and black battery connector out of the battery pack in the slit provided
on the front flap.
4. Close the battery pack by performing the following -
A. Fold down the front flap and press to engage the hook and loop straps.
B. Fold down the side flaps and press to engage the hook and loop straps.
NOTE: Ensure that the hook and loop straps are securely fastened before lifting the battery pack.
5. Install the battery pack on the wheelchair. Refer to Removing/Installing the Battery
Pack on the At’m on page 45.
FIGURE 8.4 Removing/Installing the Batteries From/Into the At’m Battery Pack
Front
Flap
Side Flap
Side
Flap
Right
Battery
Left
Battery
Right Battery
Left
Battery
Slot
Battery Pack
DETAIL “A” - BATTERY WIRING
RED and BLACK
Battery Connector
NEGATIVE
Terminal
POSITIVE
Terminal
NEGATIVE
Terminal
POSITIVE
Terminal
Circuit
Breaker
NEGATIVE BLACK
Battery Cable
POSITIVE RED
Battery Cable