Filter
Top Products
SECTION 8—BATTERIES
Part No. 1125078 53 At’m and At’m QT
Charger Plugged Into the Joystick
NOTE: For this procedure, refer to FIGURE 8.7.
NOTE: The charger port located on the front of the joystick requires the use of an independent
charger. The independent charger is supplied with the wheelchair.
1. Attach the battery charger connector to
the charger port on the front of the
joystick.
2. Plug the charger’s AC power cord or
extension into the grounded 110-volt
wall outlet.
3. When charging is complete, turn
charger off.
4. Disconnect output cable from joystick
charger port.
FIGURE 8.7 Charging Using an
Independent Charger - Charger Plugged Into
the Joystick
Charger Plugged Directly to Batteries - At’m Only
NOTE: For this procedure, refer to FIGURE 8.8.
1. Disconnect the RED and BLACK connector from the wheelchair harness.
2. Connect 3-pin charger connector to the female 3-pin connector on the charger jumper
cable (supplied).
3. Connect RED and BLACK connector on the charger jumper cable to the RED and
BLACK connector on the battery pack.
4. Plug the charger’s AC power cord into the grounded 110-volt wall outlet.
5. When charging is complete, turn charger off.
6. Disconnect the charger jumper cable from the battery pack.
7. Reconnect the RED and BLACK connector from the battery pack to the wheelchair
harness.
FIGURE 8.8 Charging Using an Independent Charger - Charger Plugged Directly to Batteries
- At’m Only
Multi-Function
Charger Port
Independent
Charger
Battery
Pack
Charger Jumper Cable
Plug into Wall Outlet
Female 3-Pin
Connector
3-Pin Charger
Connector
AC Power Cord
RED and
BLACK Battery
Connectors