Filter
Top Products
SECTION 10—FRONT RIGGINGS
At’m and At’m QT 66 Part No. 1125078
Removing
1. Push the front rigging release lever inward while rotating the front rigging assembly
outward.
2. Lift the front rigging assembly out of the front rigging support bracket.
3. Repeat STEPS 1-2 for the other front rigging assembly, if necessary.
FIGURE 10.2 Installing/Removing the Front Rigging Assembly
Adjusting Footrest Height
NOTE: For this procedure, refer to FIGURE 10.3.
1. Remove the front rigging assembly. Refer to Installing/Removing the Front Rigging
Assembly on page 65.
2. Remove the hex screw and coved spacer.
3. Move the footrest with slide tube up or
down on its mounting tube until the
desired footrest height is achieved.
4. Install the hex screw and coved spacer
through the front rigging upper
support and the slide tube. Securely
tighten.
5. Install the front rigging assembly. Refer
to Installing/Removing the Front
Rigging Assembly on page 65.
6. Repeat STEPS 1-5 for the other side, if
necessary.
FIGURE 10.3 Adjusting Footrest Height
Seat Frame Tube
Footrest
Mounting Pin
Front Rigging
Assembly
Front Rigging
Support Bracket
Front Rigging
Release Lever
Outside of
Wheelchair
Inside of
Wheelchair
Footrest
Coved
Spacer
Hex
Screw
Front Rigging
Upper Support
Slide
Tube