Filter
Top Products
SECTION 9—MOTORS
At’m and At’m QT 62 Part No. 1125078
5. Remove the motor from the base frame. Refer to Removing/Installing the Motors on
page 60.
6. Remove the swing arm screw.
7. Remove the swing arm bracket screw.
8. Remove the two shroud screws securing the cylinder shroud.
9. Remove the cylinder shroud.
10. With a 1/8-inch punch and hammer, gently tap out the roll-pin that secures the
knurled drive cylinder to the drive shaft.
CAUTION
DO NOT use excessive force handling the roll-pin, otherwise damage will occur.
11. Slide the knurled drive cylinder off the drive shaft.
12. Install a new knurled drive cylinder onto the drive shaft.
13. Align the holes in the knurled drive cylinder with the holes in the drive shaft.
14. Insert a new roll pin into the mounted knurled drive cylinder.
15. With a 1/8-inch punch and hammer, gently tap the roll-pin into place.
CAUTION
DO NOT use excessive force handling the roll-pin, otherwise damage will occur.
16. Install the cylinder shroud and align it with swing arm and swing arm bracket.
17. Secure the cylinder shroud with the two shroud screws.
18. Secure the swing arm bracket with the one swing arm bracket screw.
19. Secure the swing arm with the one swing arm screw.
20. Install the motor to the base frame. Refer to Removing/Installing the Motors
on
page 60.
21. Install the motor shroud. Refer to Removing/Installing Motor Shroud on page 57.
22. Install the battery pack/box. Refer to Removing/Installing the Battery Pack on the At’m
on page 45 or Removing/Installing the Battery Box on the At’m QT on page 46.
23. Install the seat. Refer to Removing/Installing the Seat
on page 31.
24. Reconnect the joystick. Refer to Disconnecting/Connecting the Joystick
on page 40