Filter
Top Products
SECTION 9—MOTORS
Part No. 1125078 59 At’m and At’m QT
4. Install the battery pack/box. Refer to Removing/Installing the Battery Pack on the At’m
on page 45 or Removing/Installing the Battery Box on the At’m QT on page 46.
5. Install the seat. Refer to Removing/Installing the Seat on page 31.
6. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.
Removing/Installing MK5 Controller
NOTE: For this procedure, refer to FIGURE 9.4 on page 59 and FIGURE 9.5 on page 60.
Removing
1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.
2. Remove the battery pack/box. Refer to Removing/Installing the Battery Pack on the
At’m on page 45 or Removing/Installing the Battery Box on the At’m QT on page 46.
3. Remove the seat. Refer to Removing/Installing the Seat on page 31.
4. Remove the motor shroud. Refer to Removing/Installing Motor Shroud on page 57.
5. From the controller, unplug the following connectors (not shown):
A. The joystick connector
B. The battery connector
C. The right motor connector
D. The left motor connector
6. Remove the two mounting screws and coved washers that secure the controller to the
base frame.
FIGURE 9.4 Removing/Installing MK5 Controller
Mounting Screws
MK5 Controller
Coved
Washer
Coved
Washer
Base
Frame
Base Plate
NOTE: Motors, drive wheels, and connectors not shown.
MK5 Controller
Mounting Screws
Base Frame
Base Plate
DETAIL “A”
DETAIL “B”