Filter
Top Products
SECTION 8—BATTERIES
At’m and At’m QT 54 Part No. 1125078
Charger Plugged Directly to Batteries - At’m QT Only
NOTE: For this procedure, refer to FIGURE 8.9.
1. If necessary, remove the battery box from the wheelchair. Refer to
Removing/Installing the Battery Box on the At’m QT on page 46.
2. Slide the charger port cap (located on the battery box) to one side.
3. Plug the charger connector into the charger port located on the battery box
(FIGURE 8.9).
4. Plug the charger power cord into 110-volt wall outlet.
FIGURE 8.9 Charging Using an Independent Charger - Charger Plugged Directly to Batteries
- At’m QT Only
Resetting the Circuit Breaker
ƽ WARNING
NEVER defeat or bypass the circuit breaker. Only replace with a circuit breaker of
the same rating.
At’m
NOTE: For this procedure, refer to FIGURE 8.10 on page 55.
1. Remove the battery pack from the wheelchair base. Refer to Removing/Installing the
Battery Pack on the At’m on page 40.
2. Open the battery pack by performing the following -
A. Grasp the side flaps and pull up.
B. Grasp the front flap and pull up.
Independent Charger
Battery Box
Plug into Wall Outlet
3-Pin Charger Connector
AC Power Cord
Charger Port on Battery Box