Filter
Top Products
SECTION 9—MOTORS
At’m and At’m QT 58 Part No. 1125078
Removing/Installing the Base Plate
NOTE: For this procedure, refer to FIGURE 9.3 on page 58.
Removing
1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 40.
2. Remove the seat. Refer to Removing/Installing the Seat on page 31.
3. Remove the battery pack/box. Refer to Removing/Installing the Battery Pack on the
At’m on page 45 or Removing/Installing the Battery Box on the At’m QT on page 46.
4. Remove the motor shroud. Refer to Removing/Installing Motor Shroud on page 57.
5. Remove the two mounting screws, washers, and locknuts that secure the front of the
base plate to the base frame.
6. Remove the two mounting bolts, washers, and locknuts to remove the left battery pack
bracket.
7. Repeat STEP 6 for the right battery pack bracket.
8. Remove the base plate.
FIGURE 9.3 Removing/Installing the Base Plate
Installing
1. Install the left battery pack bracket using two mounting bolts, washers, and locknuts.
2. Repeat STEP 1 for the right battery pack bracket.
3. Secure the base plate on the base frame using the two mounting screws, washers, and
locknuts. Securely tighten.
Mounting Screws
Mounting
Bolts
Right Battery Pack Bracket
Left Battery Pack
Bracket
Washers
Locknuts
Base Frame
Base Plate