Filter
Top Products
1594A/1595A Super-Thermometer
Main Menu
32
5.7.1.2.1.1.3 EDIT RESISTOR (F2)
MAIN MENU | CHANNEL SETUP | CHANNEL SETTINGS | SET UP Rs | DEFINE RESISTOR |
The Edit Resistor function key opens the highlighted Rs denition for editing. The conguration elds are
explained in the Add Resistor section above.
5.7.1.2.1.2 READ RESISTOR (F3)
MAIN MENU | CHANNEL SETUP | CHANNEL SETTINGS | SET UP Rs | DEFINE RESISTOR |
Read Resistor allows the user to load a pre-congured reference resistor denition from a USB memory
device.
To load a resistor denition, insert a USB memory device that contains a resistor conguration into the front
panel. Allow about 10 seconds for the system to recognize the USB device and then press OK (F5). A list of
resistor denition les stored on the memory device appears on the screen. Scroll through the list using the
Up/Down arrow keys and select the le to be loaded. Press OK (F5) to begin the le transfer. A message will
prompt the user to continue.
Tip: Resistor denition les must be located in a folder named “\159x\resistor” on the USB memory
device. The les must have the extension “.res” and contain resistor denition data in the proper format.
This type of le can be created by using the Write File function, see Section 5.7.1.2.1.3.2, WRITE FILE
(F2), on page 32 in the Manage Resistors menu.
5.7.1.2.1.3 MANAGE RESISTORS (F3)
MAIN MENU | CHANNEL SETUP | CHANNEL SETTINGS | SET UP Rs |
Rs resistor denitions in the resistor denition library may be added, deleted, or prioritized in the Manage
Resistors menu using the following function keys.
5.7.1.2.1.3.1 READ FILE (F1)
MAIN MENU | CHANNEL SETUP | CHANNEL SETTINGS | SET UP Rs | MANAGE RESISTORS
The Read File function key allows the user to import an entire set of resistor denitions from a le on a USB
memory device.
Every resistor denition in the resistor denition library must have a unique ID. If a resistor denition in the
library has the same ID as one read from the USB memory device, it will be replaced.
Tip: Resistor denition les must be located in a folder named “\159x\resistor” on the USB memory
device. The les must have the extension “.res” and contain resistor denition data in the proper format.
This type of le can be created by using the Write File function, see Section 5.7.1.2.1.3.2, WRITE FILE
(F2), on page 32 in the Manage Resistors menu.
5.7.1.2.1.3.2 WRITE FILE (F2)
MAIN MENU | CHANNEL SETUP | CHANNEL SETTINGS | SET UP Rs | MANAGE RESISTORS
The Write File function key in the Manage Resistors menu allows the user to export one resistor denition or
the entire library to a le on a USB memory device.
If a resistor was selected in the Manage Resistors screen, that resistor denition will be written to a le. If ALL
RESISTORS was selected, the entire Resistor Library will be written to a le.
The screen shows the name of the le to be written. The user may change the name of the le by pressing
ENTER to open the alpha-numeric editing screen. Finally, the user presses the CONTINUE function key to