Filter
Top Products
Storing and Loading Controller Configurations
10-5
4. To load a parameter set to the selected controller, click on Load. The Open
Parameter Set window will open.
5. Select the name of the .PRF file to be loaded to the controller and click on OK. The
parameter values stored in the file will be written to the controller.
6. As the load progresses, status windows will be displayed. When no more status
windows are displayed, the load has completed successfully. If the CN8-SW system
could not write all the parameter values in the .PRF file to the controller, messages
containing the parameter numbers will be displayed. Usually a parameter value
cannot be written to the controller because the hardware does not support the feature
that uses the parameter. Note the parameter numbers in the messages, then check
the controller manual to determine the names of the parameters. If the parameters
apply to your application, configure the parameters individually.