Filter
Top Products
9-1
9. Configuring and Running
Ramp and Soak Recipes
9.1 Introduction
Use the CN8-SW Ramp and Soak function to configure any number of recipes consisting
of any number of ramp and soak steps. These recipes are stored on the CN8-SW
computer. Under the direction of CN8-SW, any controller on the network can execute
your choice of recipe, even models that do not support configuration and execution of
ramp and soak cycles using the controller front panel. Instructions for configuring these
recipes are in 9.2. Instructions for running these recipes are in 9.3.
The CN8-SW displays also provide a quick way to configure and run recipes that use the
controllerÕs own recipe parameters. Instructions for configuring these recipes are in 9.4.
Instructions for running these recipes are in 9.5.