Filter
Top Products
[ 84 ] Pelco Manual C1977M-D (6/02)
Connecting Pelconet To DX3000 For Recording
Refer to Figure 50. This configuration lets an operator remotely view, record, and playback video on a
DX3000 digital video recorder.
• Set the control terminal port to COM2 and 1200, 8, NONE, 1.
• Connect the monitor output from the DX3000 to the video input on the PelcoNet transmitter.
• Connect the NULL modem cable from the RS-232 port on the back of the DX3000 to the control terminal port on the PelcoNet trans
mitter
.
• Enable Microsoft VM in Internet Explorer by going to: Tools -> Internet Options -> Advanced -> Microsoft VM. Enable all three options and
reboot.
Figure 50. Using PelcoNet with a DX3000 Recorder
1
MIC
IN
OUT
23456789
1
RS-23 2 C
234
1
GND
23456789
CA MERA
IN
AUDIO
CAM ERA O UT
ALARM IN
56789
ON OFF
SCSI
Y/ C
VIDEO
OUT
GND
RESET
SCSI
TERMIN ATION
FRAME
RSD 2
TXD 3
DTR 4
SG 5
DSR 6
RTS 7
CTS 8
FRAME
2 RSD
3 TXD
4 DTR
5 SG
6 DSR
7 RTS
8 CTS
BAUD RATE: 1200
DATA BITS: 8
PARITY: NONE
STOP BITS: 1
BAUD RATE: 1200
DATA BITS: 8
PARITY: NONE
STOP BITS: 1
DELIMITER: CR
DX3000
00670