Filter
Top Products
[ 28 ] Pelco Manual C1977M-D (6/02)
Command Reference
The following table gives an overview of all available commands. (Enter the appropriate information
where indicated by the quotation marks below. Do not enter the quotation marks.)
Table A. Terminal Command Reference
Cmd Description
?Displays the help screen.
i Set up a new IP address.
->Enter new IP address (old:192.168.0.1): ‘new IP
address’ [Enter]
->IP address set to <new IP address>
s Set up a new subnet mask.
->Enter new subnet mask (old:255.255.255.0): ‘new
subnet mask’ [Enter]
->subnet mask set to <new subnet mask>
g Set up a new gateway IP address.
->Enter new gateway IP address (old:192.168.0.10):
‘new gateway IP address’ [Enter]
->gateway IP address set to <new gateway IP address>
a Set up a new alarm IP to connect to.
->Enter new alarm IP address old:192.168.0.3): ‘new
alarm IP address’ [Enter]
->Alarm IP address set to <new alarm IP address>
c Connects a live video to the specified alarm IP.
->connecting... PelcoNet tries to call the alarm IP host
connected PelcoNet has established the connection
dDisconnects any pending video connection.
->disconnecting... PelcoNet disconnects
disconnected PelcoNet has disconnected
mDisplay the unit’s MAC address.
->MAC address: <unit’s MAC address>
(Continued on next page)