Filter
Top Products
Pelco Manual C1977M-D (6/02) [ 65 ]
Test Between Audio-Equipped Transmitter and PC
1. Connect a microphone (via a preamplifier) to the Line-In cinch plug or connect a handset to the RJ-11
plug on the unit.
2. Make sure the correct menu items are set in the Audio Configuration Page—that is, select the appro-
priate interface (line in/out or handset).
3. Switch the coding mode to G.711 or G.728.
4. Select a volume above zero.
5. Connect a loudspeaker to the PC’s soundcard. After establishing the Ethernet connection, audio
should be transmitted both ways.
6. Be sure not to set the level too low. Ensure the right interface is selected.
7. If you cannot hear any audio, check the microphone and loudspeaker together with other equipment.
Make sure the microphone is switched on if it has a power switch.
DX3000 Warning Reset Button
PelcoNet displays a warning message if there is a problem with the DX3000 DVR. Click this green button
to reset the unit. The codes are defined as follows:
Code Definition
00 None
01 Hard drive full
02 Hard drive near end
03 No signal
04 Copy or backup or restore—check media
05 Copy or backup or restore—size error
06 Archive full
07 Archive near end
08 Copy or backup—overtake error
09 Copy or backup—near overtake
10 Recording or copy or backup or restore or system—system error
11 Copy or backup or restore—read/write error