Lifescan SPD2410BD Blood Glucose Meter User Manual


 
SETTINGS
62
United States. If you are not sure which unit of
measurement to use, please check with your
Health Care Professional. The mmol/L results
include a decimal point and the mg/dL results
do not.
To change the unit of measurement to
mg/dL, press the green C button.
This symbol will flash on the display.
Press the blue power button to move to the
beep signals setting.
Beep Signals
The OneTouch
®
SureStep
®
Meter uses beep-
ing tones to signal certain steps in the proce-
dure. However, these “beep” signals do not
mean that the step was performed correctly.
Three types of beep signals sound.
1. A single, short beep identifies each step
in the test procedure.
2. A single, long beep accompanies error
messages, a “
HI
” result, and certain mis-
takes in doing the test procedure.
3. A three–tone beep sounds when the
meter displays a test result and when the
meter moves to the beep signal feature
in set–up mode.
DCO_05090602A_OTSS_OB_CA_ENG 12/3/03 1:27 PM Page 62