Filter
Top Products
5. Turn the test strip over and check to see
that the confirmation dot is completely
blue. If it is not, discard the test strip.
Repeat the test with a new test strip,
applying a larger drop of control solution
to the centre of the pink test square.
CAUTION: If you do not firmly insert the
test strip into the meter until it stops, you
may get an inaccurately low result.
IMPORTANT: Immediately insert the test
strip after applying the control solution. If
you do not insert the test strip within 2 min-
utes, discard the test strip and start over
with a new test strip.
6. Firmly insert the
test strip, confirma-
tion dot side down,
into the test strip
holder until
it stops.
CHECKING
18
DCO_05090602A_OTSS_OB_CA_ENG 12/3/03 1:27 PM Page 18