Filter
Top Products
Part No. 1052712 Rev D 57 Terminator SS
REPOSITIONING QUICK RELEASE LEVERS (FIGURE 6)
NOTE: This procedure should only be performed if quick release levers are on top of the axle
mounting tube and interfere with the desired rear seat-to-floor adjustment. This procedure will
position the quick release lever on the bottom of the axle tube.
1. Remove the threaded knob from the quick release lever.
2. Remove the quick release lever, recessed washer and coved washer from the
camber clamp.
3. If necessary, position the recessed washer and coved washer onto the quick release
lever, as shown in FIGURE 6.
4. Insert the quick release lever with washers through the camber clamp as shown in
FIGURE 6.
FIGURE 6 - REPOSITIONING QUICK RELEASE LEVERS
Threaded
Knob
Recessed Washer
and Coved Washer
Quick Release Lever
Camber Clamp
SIDE VIEW OF CAMBER CLAMP WITH QUICK RELEASE LEVER
REVERSE
POSITIONS
LEVER ON
CLAMP TOP
LEVER ON CLAMP
BOTTOM
SUSPENSION PROCEDURE 7
SUSPENSION