Filter
Top Products
Terminator SS 46 Part No. 1052712 Rev D
SECTION 6 FOOTREST/ANTI-TIPPER
FOOTREST / ANTI-TIPPER
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage may result.
ALWAYS perform this procedure in the presence of an assistant. The position
of the footrest, camber tube, back angle, the tautness of the back upholstery as
well as the user's condition are directly related to the wheelchairs stability. Any
change to one (1) or any combination of the five (5) may cause the wheelchair to
decrease in stability. Use EXTREME caution when using a new seating
position. The addition of anti-tippers may be required.
Check ALL allen screws that secure the footrest/raised footrest system to
the wheelchair frame to make sure they are securely tightened BEFORE
using the wheelchair, ESPECIALLY if engaging in ANY contact sport.
The footrest assembly MUST be at least 1-3/4-inches above the ground/
floor to avoid hitting protruding objects when using this wheelchair.
ADJUSTING/REPLACING STANDARD FOOTREST
(FIGURE 1)
1. Loosen the two (2) allen screws that secure the footrest to the wheelchair frame.
IF REPLACING THE FOOTREST:
1. Remove EXISTING footrest.
2. Install NEW footrest.
WARNING
The standard footrest has an open
hoop. A footplate cover is
recommended for wheelchair users
that have leg spasticity or whose feet
have a possibility of falling through the
footrest hoop. A calf strap is provided
with each wheelchair to prevent the
feet from slipping backwards off of the
footrest. Be sure the calf strap is
secure when using the wheelchair.
IF REPLACING OR ADJUSTING THE FOOTREST:
1. Position NEW/EXISTING footrest to desired height.
2. Tighten the two (2) allen screws that secure the footrest to the wheelchair frame.
Section 6 - Footrest/Anti-tipper - includes the following:
Adjusting/Replacing Standard Footrest
Installing/Adjusting Optional Clamp on Raised Footrest
Installing/Adjusting Optional A4 Footrest
Anti-Tipper Replacement/Adjustment
Footrest
Wheelchair
Frame
Allen Screws
(Not Shown)
FIGURE 1 - ADJUSTING/REPLACING
STANDARD FOOTREST