Filter
Top Products
Terminator SS 32 Part No. 1052712 Rev D
ADJUSTING REAR WHEEL CAMBER
CAMBER TUBE 2000
The axle tube must be replaced to change the camber. Refer to REPLACING AXLE
TUBE in this section of the manual.
A4 CAMBER SYSTEM (FIGURE 7)
NOTE: Perform this procedure to one (1) side of
the wheelchair at a time for ease of adjustment.
1. Open the camber clamp. Refer to
OPENING/CLOSING CLAMPS in this
section of the manual.
2. Pull one (1) rear wheel with camber
insert out of axle tube.
3. Remove the rear wheel from the
camber insert.
4. Rotate the camber insert 180
o
.
5. Reinstall the rear wheel into the
camber insert.
WARNING
NEVER position the camber inserts in the axle tube with more than 3-
inches (12 indexing marks showing) of the camber insert outside of the axle
tube. The camber inserts will not be securely tightened in the axle tube
resulting in possible injury to the user and/or damage to the wheelchair.
6. Position the camber insert to the desired position. Make sure there is no more than
3-inches (12 indexing marks) of the camber inserts outside of the axle tube.
7. Slide the indexing ring on the camber insert until it is flush with the camber clamp.
NOTE: Before using the wheelchair, make sure both camber inserts are set to the same indexing mark.
This will make sure the distance between the rear wheel and the wheelchair is the same on both sides.
WARNING
QUICK RELEASE LEVERS - Make sure the quick release levers are pointing
towards the rear of the wheelchair and are in the CLOSED position BEFORE
using the wheelchair, otherwise personal injury or damage to the wheelchair
may result.
STANDARD - Make sure the hex screws and locknuts are securely tightened
BEFORE using the wheelchair, otherwise personal injury or damage to the
wheelchair may result.
8. Close the camber clamp. Refer to OPENING/CLOSING CLAMPS in this section of
the manual.
9. Repeat STEPS 1-8 for opposite side of wheelchair.
WHEELS
WHEELSSECTION 5
Rear View of Wheelchair
FIGURE 7 - ADJUSTING REAR
WHEEL CAMBER -
A4 CAMBER SYSTEM
Camber Insert -
Rotate 180
o
Axle Tube
Camber
Clamp
Indexing Marks
Indexing Ring