Filter
Top Products
Terminator SS 42 Part No. 1052712 Rev D
WHEELSSECTION 5
WHEELS
10. Reposition the camber inserts to the highest degree of camber. Refer to ADJUSTING
REAR WHEEL CAMBER in this section of the manual.
11. Repeat STEP 3.
12. Close the LEFT camber clamp. Refer to
OPENING/CLOSING CLAMPS in this
section of the manual.
13. Rotate the RIGHT toe adjustment ring until the tab stops against the UPPER metal
tab on the camber clamp.
14. Securely tighten set screw on RIGHT toe adjustment ring.
15. Repeat STEP 7.
16. Perform one (1) of the following:
A. TOE IN/TOE OUT MEASUREMENT IS WITHIN ±1/8-INCH -
i. Proceed to STEP 17.
B. TOE IN/TOE OUT MEASUREMENT IS NOT WITHIN ±1/8-INCH -
i. Repeat STEP 1.
ii. Loosen the set screw on the right toe adjustment ring.
iii. Repeat STEP 3.
iv. Repeat STEPS 12-16 until toe in/toe out measurement is within ±1/8 inch.
17. If desired, reposition camber inserts to the desired degree of camber. Refer to
ADJUSTING REAR WHEEL CAMBER in this section of the manual.
Place "L" Square Here
90° Angle
Flat Edge of
Camber Insert
LOWER DEGREE OF CAMBER
Metal Tab
Camber Clamp
Axle Tube
Set Screw
Tab
LEFT Toe
Adjustment
Ring
Axle Tube - Will Rotate UP Only
HIGHER DEGREE OF CAMBER
RIGHT Toe
Adjustment
Ring
Axle Tube
Set Screw
Camber
Clamp
Tab
Metal
Tab
FIGURE 18 - ADJUSTING THE AXLE TUBE - A4 CAMBER SYSTEM
Axle Tube - Will Rotate DOWN Only
Ground/
Floor