Filter
Top Products
Terminator SS 48 Part No. 1052712 Rev D
SECTION 6 FOOTREST/ANTI-TIPPER
FOOTREST / ANTI-TIPPER
FIGURE 3 - INSTALLING/ADJUSTING OPTIONAL A4 FOOTREST
Allen Screws
Footrest
Tube
Flat
Screws
Footplate
Flat Screws
DEPTH
HEIGHT
ANGLE
FOOTPLATE DEPTH ADJUSTMENT
1. Loosen, but do not remove the four (4) flat screws and locknuts that secure
footplate to the footrest tubes.
NOTE: Observe the angle of footplate for reinstallation.
2. Move the footplate to one (1) of two (2) positions to accommodate the user.
3. Retighten the four (4) flat screws and locknuts.
NOTE: The settings for positioning the footplates on the half-clamps may vary for each end-user.
NOTE: The locknuts should lie in the channel of the footplate half clamp.