Filter
Top Products
Part No. 1052712 Rev D 51 Terminator SS
FIGURE 1 - REPLACING REAR ELASTOMERS
LOWER Elastomer
Recessed Spacer
Telescoping Tube
Mounting Bolt
Locknut
Nylon Washer
Nylon Washer
Suspension Arm
UPPER Elastomer
4. Install the locknut onto the mounting bolt.
NOTE: It may be necessary to compress the rear suspension system to install the locknut onto the
mounting bolt.
5. Tighten the locknut until three (3) threads can be seen on the end of mounting bolt.
6. Ensure wheel locks engage properly. Refer to WHEEL LOCK
ADJUSTMENT/REPLACEMENT in SECTION 5 of the manual.
SUSPENSION SECTION 7
SUSPENSION