Filter
Top Products
Part No. 1052712 Rev D 39 Terminator SS
REPLACING AXLE TUBE (FIGURE 16)
NOTE: The camber bar is always mounted to the BOTTOM of the wheelchair frame.
NOTE: There is no need to remove the two (2) camber clamps when replacing the axle tube.
1. A4 CAMBER SYSTEM ONLY - Note the position of the camber inserts so they can
be installed at the same position in the new axle tube.
2. Open the camber clamps. Refer to
OPENING/CLOSING CLAMPS in this section of
the manual.
3. Remove the (2) rear wheels. Refer to
REMOVING/INSTALLING REAR WHEELS in
this section of the manual.
4. A4 CAMBER SYSTEM ONLY - Remove the camber inserts positioned in the axle tube.
5. A4 CAMBER SYSTEM ONLY - Loosen, but do not remove the two (2) phillips
screws that secure the toe adjustment rings to the axle tube.
FIGURE 16 - REPLACING AXLE TUBE
Camber Clamp
Axle Tube
Toe Adjustment
Ring
Slot in Axle Tube
Camber Insert
REAR OF
WHEELCHAIR
Notch in
Axle Tube
Camber Insert
Indexing
Ring
Toe Adjustment Ring
Set Screw
FRONT OF
WHEELCHAIR
Axle
Tube
Camber
Clamp
CAMBER
TUBE 2000
FRONT OF
WHEELCHAIR
REAR OF
WHEELCHAIR
A4 CAMBER
SYSTEM
WHEELS SECTION 5
WHEELS
Set Screw