Filter
Top Products
Terminator SS 20 Part No. 1052712 Rev D
BACKSECTION 3
BACK
Replacing Top End Back Upholstery.
1. Unlatch the two (2) fastening flaps that secure the top of the back upholstery to the
back canes.
2. Remove the fastening flaps from the back canes by lifting straight up.
3. Remove the seat cushion.
4. Separate the bottom of the back upholstery from either the underside or top of the
seat upholstery (depending on back style).
5. Install the NEW fastening flaps onto the back canes.
NOTE: The fastening flap with logo is for the left back cane.
NOTE: Right and left is determined by sitting in the wheelchair.
6. Securely latch the bottom of the back upholstery to the fasteners on either the
underside or top of the seat upholstery (depending on back style).
7. Adjust the NEW back upholstery to the desired tautness. Refer to ADJUSTING
TOP END BACK UPHOLSTERY in this section of the manual.
FIGURE 3 - ADJUSTING/REPLACING BACK UPHOLSTERY -
TOP END BACK UPHOLSTERY
Fastening
Flap with
Logo
Seat
Upholstery
Back Upholstery
Wheelchair
Frame
Fastening Flap
Bottom of Back
Upholstery