Filter
Top Products
Part No. 1052712 Rev D 27 Terminator SS
ADJUSTING QUICK-RELEASE AXLES (FIGURE 2)
1. Remove rear wheel and quick-release axle from the wheelchair. Refer to
REMOVING/INSTALLING REAR WHEELS in this section of the manual.
2. Depress detent pin in the quick-release axle and slide axle through the wheel hub.
3. Release detent pin ensuring that the locking pins are fully released.
4. Increase or decrease end play by adjusting the locknut on the end of the
quick-release axle.
5. Reinstall rear wheel onto the wheelchair. Refer to REMOVING/INSTALLING REAR
WHEELS in this section of the manual.
WARNING
Pull on the rear wheel to make sure the detent pin and locking pins of the
quick/quad-release axle are fully released BEFORE operating wheelchair.
Keep locking pins clean.
4. If there is too much movement of the rear wheel assembly in a back and forth motion,
refer to
ADJUSTING QUICK-RELEASE AXLES or ADJUSTING QUAD-RELEASE
HANDLES in this section of the manual.
FIGURE 2- ADJUSTING QUICK-RELEASE AXLES
Adjustable Axle Position
Camber Bar
NOTE: End of Quick
Release axle is shown for
reference only. It is not
visible when inserted into
camber bar
Locking Pins
Quick Release Axle
Locknut
Wheel Hub
Detent Pin
Quick-Release
Axle
Wheelchair
Frame
Detent Pin
Locking Pins
NOTE: Quad-Release Axle not shown. Locking pins the same as Quick-Release Axle.
Rear Wheel
FIGURE 1 - REMOVING/INSTALLING REAR WHEELS
WHEELS SECTION 5
WHEELS