Filter
Top Products
Part No. 1052712 Rev D 31 Terminator SS
WHEELS SECTION 5
RECEIVER TUBE CLAMPS
1. Perform one (1) of the following to open a receiver tube clamp:
A. QUICK RELEASE LEVERS - Pull the quick release levers on the receiver
tube clamps to the open position.
B. STANDARD RECEIVER TUBE CLAMPS - Loosen, but do not remove the
hex screws and locknuts on the receiver tube clamps.
2. Perform one (1) of the following to close a receiver tube clamp:
A. QUICK RELEASE LEVERS - Tighten the threaded knob to secure the quick
release lever. Push the quick release lever on the receiver tube clamps to the
closed position.
B. STANDARD RECEIVER TUBE CLAMPS - Tighten the hex screw and
locknut on the receiver tube clamp. Torque to 75 in./lbs.
RECEIVER TUBE CLAMPS
FIGURE 6 - OPENING/CLOSING CLAMPS
STANDARDQUICK RELEASE LEVER
CLOSED POSITION
Quick
Release Lever
OPEN POSITION
Hex Screw
Locknut
Threaded Knob
CAMBER CLAMPS
CLOSED
POSITION
Quick Release
Lever
QUICK RELEASE LEVER
STANDARD
OPEN
POSITION
Hex Screw
and Locknut
WHEELS