Filter
Top Products
Terminator SS 34 Part No. 1052712 Rev D
WHEELSSECTION 5
WHEELS
ADJUSTING TOE IN/TOE OUT
CAMBER TUBE 2000 (FIGURE 10)
1. Open the camber clamps. Refer to
OPENING/CLOSING CLAMPS in this
section of the manual.
2. Slowly rotate the camber tube in
either direction until the rear wheels
are approximately in a straight line.
3. Close the camber clamps. Refer to
OPENING/CLOSING CLAMPS in this
section of the manual.
4. Measure the distance between the center lines at the rear and front of the rear
wheels at approximately 12-inches from the ground/floor. Refer to DETERMINING
TOE IN/TOE OUT in this section of the manual.
5. Repeat STEPS 1-4 until the toe in/toe out measurement is less than 1/2-inch (0 + 1/4-inch
for maximum rollability).
A4 CAMBER SYSTEM
Course Adjustment (FIGURE 11).
NOTE: This procedure is required any time the axle tube is moved from the factory set position or
is replaced.
NOTE: Make the following adjustment for one (1) camber at a time.
1. Open the camber clamps. Refer to OPENING/CLOSING CLAMPS in this section of
the manual.
2. Loosen the phillips screws that secure the adjustment rings to the axle tube.
3. Slowly rotate the axle tube until the rear wheels are approximately in a straight line.
WARNING
QUICK RELEASE LEVERS - Make sure the quick release levers are
pointing towards the rear of the wheelchair and are in the CLOSED
position BEFORE using the wheelchair, otherwise personal injury or
damage to the wheelchair may result.
WARNING
STANDARD - Make sure the hex screws and locknuts are securely
tightened BEFORE using the wheelchair, otherwise personal injury or
damage to the wheelchair may result.
4. Close the camber clamp. Refer to OPENING/CLOSING CLAMPS in this section of
the manual.
Camber Tube - Rotates Up and Down
Camber Clamps
FIGURE 10 - ADJUSTING TOE IN/
TOE OUT - CAMBER BAR 2000