Filter
Top Products
Part No. 1052712 Rev D 47 Terminator SS
INSTALLING/ADJUSTING OPTIONAL CLAMP ON
RAISED FOOTREST (FIGURE 2)
INSTALLING
1. Install the two (2) half clamps onto
either side of the wheelchair frame
approximately 2-inches above existing
footrest with two (2) allen screws
provided.
2. Repeat for the opposite side of the
wheelchair.
3. Slide the clamp on raised footrest into
the half clamps to the desired height.
4. Securely tighten the four (4) allen screws.
ADJUSTING
1. Loosen the four (4) allen screws.
2. Adjust clamp on raised footrest to the desired height.
3. Securely tighten all four (4) allen screws.
INSTALLING/ADJUSTING OPTIONAL A4 FOOTREST
(FIGURE 3)
REPLACING THE FOOTREST
1. Loosen, but do not remove the two (2) allen screws that secure the footrest to the
wheelchair frame.
2. Slide the EXISTING footrest tubes out of the wheelchair frame and install NEW
footrest by reversing this step.
3. Position the NEW footrest to a determined height.
4. Tighten the two (2) allen screws that secure the footrest to the wheelchair frame.
5. Adjust the footplate to the desired position. Refer to FOOTPLATE ANGLE ADJUSTMENT
and/or FOOTPLATE DEPTH ADJUSTMENT in this section of the manual.
FOOTPLATE ANGLE ADJUSTMENT
1. Loosen, but do not remove the four (4) flat screws and locknuts that secure the
footplate to the two (2) footrest tubes.
2. Position the footplate to the necessary angle to accommodate the user.
3. Retighten the four (4) flat screws and locknuts.
NOTE: The locknuts should be placed in the channel of the footplate half clamp.
FOOTREST/ANTI-TIPPER SECTION 6
FOOTREST / ANTI-TIPPER
Outside
Footrest
Hoop
Allen
Screws
Half Clamp
Raised
Footrest
FIGURE 2 - INSTALLING/
ADJUSTING OPTIONAL CLAMP
ON RAISED FOOTREST
Wheelchair Frame