Filter
Top Products
Part No. 1052712 Rev D 21 Terminator SS
CUSTOM MANUAL ADJUSTABLE TENSION BACK
UPHOLSTERY (FIGURE 4)
The Adjustable Tension Straps.
The straps can be adjusted at various levels of tension to accommodate individual end-users.
The bottom two (2) straps can be adjusted tightly to support and/or assist the extensor
muscles.
The Back Upholstery Cover.
The back upholstery cover is designed for three (3) reasons:
1. It is a modesty cover.
2. It keeps the cushion from sliding out of the back of the wheelchair.
3. It is a sacral support depending upon how far or tight the flap is pulled under the
seat cushion.
Replacing Adjustable Tension Back Upholstery.
1. Remove the back height adjustment screws that secure the back canes to the back uprights.
2. Slide the back canes out of the back uprights.
3. Remove the two (2) screws and washers that secure the EXISTING back upholstery
to the back canes.
4. Slide the EXISTING back upholstery down and off the back canes.
5. Stand behind the wheelchair and perform the following:
A. Slide anchor loop section of adjustable tension back upholstery up onto the LEFT
back cane with the upper grommet hole facing the rear of the wheelchair.
B. Slide adjuster strap section of adjustable tension back upholstery up onto the
RIGHT back cane with the upper grommet hole facing the rear of the wheelchair.
6. Align the mounting hole in each back cane with the desired mounting hole in each
back upright.
NOTE: Both back canes should be adjusted to the same height.
7. Install the two (2) back height adjustment screws through the back upright mounting
holes determined in STEP 6 and the back cane mounting holes.
8. Slip adjuster straps through corresponding anchor loops and adjust the back
upholstery. Secure with the fastening straps.
BACK SECTION 3
BACK