Filter
Top Products
4. INSTALLATION
4-15
4.7.5 Flash Beacon
The LED of the Flash Beacon can be adjusted externally. Connect a junction box (lo-
cal supply) and external dimmer (3 kΩ, local supply) as shown below to enable the
adjustment.
To use an external dimmer, set the jumper block JP1 to the 1-2 position.
4.7.6 How to fabricate cables for the Cabin Panel, Timer Reset Panel,
Flash Beacon and Motion Detector
Fabricate the above-mentioned cables as shown below.
JUNCTION
BOX
FLASH
BEACON
DIMMER
L=Length between cable
clamp and terminal
Sheath
Armor
Cut sheath. Remove paint approx. 50 mm.
Vinyl
tape
Set this part
in cable clamp.
Connect cores to
WAGO terminal block.