Filter
Top Products
3 • Configuring the DACS for operation Model 3095 mDSL DACS Getting Started Guide
42 Using a Web browser to complete Model 3095 configuration
7. Click on the "Submit Query" button located to the right of the static connection entry you just com-
pleted.
Example 3
Connect two mDSL modems together - mDSL modem #15, time slots 1 - 32 (for a DTE data rate of 2.048
Mbps) to mDSL modem #16, time slots 1 - 32.
Solution: Complete the following steps.
1. Under "Dev Type A," select mDSL(3).
2. Under "Dev Num A," select port15(15).
3. Under "Dev Slots A," enter 1 - 32.
4. Under "Dev Type B," select mDSL(3).
5. Under "Dev Num B," select port16(16).
6. Under "Dev Slots B," enter 1 - 32.
7. Clilck on "
Submit Query" to the right of the static connection entry which you just completed.
Note At this point the DS0 channel mapping is completed. Now we need
to configure the DTE data rate of the mDSL modem.
8. Click on mDSL on the
3095 Configuration Menu.
9. On the
Configuration/information pane, click on the number "15" under the column titled "Port."
10. Change the
Configuration State
pull-down menu to
modifyConfiguration(1)
and click on Submit Query.
11. Click on the
Modify Configuration hyperlink.
12. At the bottom of the pane, change DTE Rate to dteRate2048(35) and click
Submit Query. You will auto-
matically return to the mDSL Port Information Page.
13. From the pull-down menu of
Configuration State
, select
onLine(0)
and click Submit Query.
14. Repeat steps 9 - 14 for mDSL modem port 16.
You have now completed the entire configuration for this example.
Setting the clocking source
This section configures the Main Reference and Fallback Reference Clock for the 3095 DACS. You can choose
any of the WAN ports, an internal oscillator or an externally provided clock for the system clock in the 3095.
The Main Reference provides the 3095’s system clock unless it fails or is disconnected. Should this occur, the
Fallback Reference will be the clocking source for the 3095’s system clock.
Do the following to set the clocking source:
1. Click on
Clocking on the Configuration Menu.
2. Connect your T1/E1 Wan connection to Wan Port #1 through the WAN port cable of the 3095. Assum-
ing this is the WAN link you wish to use as the
Main Reference, set Main Reference to
wan-1(1)
(see
figure 22).