Filter
Top Products
Cable installation 23
Model 3095 mDSL DACS Getting Started Guide 2 • Hardware installation
4. Place the DACS at the desired position in the rack.
5. Secure the DACS in position with the mounting screws.
Cable installation
This section describes installing the power, ground, and network interface cables.
Installing the power cables—AC Power Supply
This section describes installing the power cables into the IEC-320 connectors on the DACS. Do not connect
the male end of the power cables to the power outlet at this time. Do the following:
1. Install a power cable into an IEC-320 connector (see figure 5). The AC main socket outlet shall be within
3 meters of the equipment and shall be easily accessible.
Figure 5. IEC-320 connector and grounding stud locations
To avoid the risk of injury from electric shock, the power cords connected to
the IEC-320 connectors must be grounded power cords.