Filter
Top Products
4 - 9
4. SYSTEM STARTUP
4.5.3 System option 2 setting
Set control mode (standard mode or interface mode) by System option 2 (parameter No.0002).
When using interface mode, select "1: Interface mode".
When interface mode is assigned and system is startup, the in interface mode signal (IFMO) turns ON.
Control mode setting is imported during system startup (system command code: 000Ah), and cannot be
changed during system running (system status code: 000Ah).
(1) System parameter
Parameter
No.
Abbreviation Name Initial value Units
Setting
range
Function
0002 *SYSOP2 System
option 2
0000h 0000h
to
1101h
Axis No. assignment
Set 1 when validating axis No.
assignment. When axis No.
assignment is invalid, axis No. is
automatically assigned.
0: Invalid
1: Valid
0
Control mode selection
Set the control mode.
0: Standard mode
1: Interface mode
Consistency check selection at
system startup
Set whether to perform consistency
check for controlled axes setting at
system startup.
0: Valid
1: Invalid